Strapping Heavy Boxes: When Tape Is Not Enough
Which tapes UPS, FedEx and USPS accept on heavy boxes, how to apply the H-tape pattern, and when each carrier allows strapping or banding.
Get free rate quotes Free account. No card needed.
For most heavy boxes, tape is enough when it is the right tape in the right pattern: pressure-sensitive plastic or reinforced tape at least 2 inches wide, run in an H across the seams on the top and the bottom. Strapping is not a general upgrade, because the carriers disagree about it. FedEx says packages should not be banded at all, USPS accepts firmly applied nonmetallic banding, and UPS allows strapped bundles of same-sized boxes only under strict conditions. Pick your carrier first, then tape or strap to that carrier's rules, as part of the wider routine in how to ship heavy packages.
Which tapes do UPS, FedEx and USPS accept on heavy boxes?
All three accept pressure-sensitive plastic tape, but they split on paper tape, so check the guide of the carrier you ship with before you stock up. The UPS packaging guidelines accept pressure-sensitive plastic tape or nylon-reinforced filament tape, and they say not to use "masking, cellophane, duct or water activated paper tapes". The FedEx packaging guidelines accept pressure-sensitive plastic tape, water-activated paper tape of at least 60-lb grade, or water-activated reinforced tape, all at least 2 inches wide. USPS, in section 601 of the Domestic Mail Manual, says tape for closing and reinforcing a box should be at least 2 inches wide, exempts pressure-sensitive filament tape from that width, and does not allow cellophane or masking tape.
| Tape rule | UPS | FedEx | USPS |
|---|---|---|---|
| Pressure-sensitive plastic tape | Accepted | Accepted, at least 2 in wide | Allowed, at least 2 in wide |
| Reinforced tape | Nylon-reinforced filament tape accepted | Water-activated reinforced tape accepted, at least 2 in wide | Pressure-sensitive filament tape allowed, exempt from the width rule |
| Water-activated paper tape | Do not use | Accepted at 60-lb grade or heavier | Allowed; kraft of at least 60-pound basis weight, extending at least 3 in over the adjoining side |
| Do not use | Masking, cellophane, duct | Cellophane, duct, masking | Cellophane, masking |
Paper tape is the trap. A box sealed with water-activated paper tape can meet the FedEx and USPS rules and still break the UPS guide. If one roll has to cover every carrier you use, pressure-sensitive plastic tape at least 2 inches wide fits all three published rules above. Duct tape feels strong, but UPS and FedEx both list it among the tapes not to use.
How do you tape a heavy box with the H pattern?
The H pattern puts one strip along the center seam where the flaps meet and one strip across each edge seam, on both the top and the bottom of the box. FedEx asks for this "H taping method" on the top and bottom. UPS describes the same layout for packages over 70 lb: on its shipping heavy items page, UPS says to seal the box with heavy-duty tape, preferably reinforced, using three strips on the top and three on the bottom so that the middle seam and both edge seams are sealed.
- Fill the box so the flaps close flat, without bulging or sinking. The fill and cushioning steps are in how to pack a heavy box.
- Run the first strip along the center seam, with each end folded down over the box side.
- Run one strip across each edge seam, where the flaps meet the end panels.
- Flip the box and repeat all three strips on the bottom, which carries the load.
- Rub every strip down so the adhesive grips the board.
- If you use gummed paper tape for USPS, let each strip extend at least 3 inches over the adjoining side.
- Leave one flat, clear panel for the shipping label, away from seams and strip ends.
Example: a 24 x 18 x 16 in box, with 3 inches of tape folded down at each end of every strip. Each face takes a 30-inch strip on the 24-inch center seam and two 24-inch strips on the 18-inch edges, which is 78 inches. The top and bottom together use 156 inches, or 13 feet, so a pack day of 20 boxes that size uses about 260 feet of tape before any extra reinforcement.
When is tape alone not enough?
Tape alone falls short when the contents are dense and loose, when the box was closed with widely spaced staples, or when the board is too weak for the weight. USPS names the first case directly. For high-density items in boxes with no inner packing or with loose material, the DMM requires reinforcement with reinforced paper or plastic tape, pressure-sensitive filament tape, or "firmly applied nonmetallic banding".
Stapled boxes have their own USPS rule. Staples should sit no more than 5 inches apart for easy loads and 2-1/2 inches apart for difficult loads. If the staples are farther apart, USPS says to apply 3-inch-wide reinforced tape across the gaps.
The third case is not a tape problem at all. If the walls bow or the bottom sags when you lift the box, more tape will not hold it together, because the board is under-rated for the load. Check the box against the weight first, using ECT and Mullen box strength ratings for heavy items, and move to a stronger box before you reach for straps.
Can you strap or band a single heavy box?
It depends on the carrier, and here the published rules point in opposite directions. FedEx says: "The package should not be bound with metal, plastic, or cloth banding." It wants the H taping method instead. USPS allows banding with conditions: the banding must go around the length and girth at least once, "loose strapping and metal strapping are not acceptable", and twine or cord should not be used. The UPS strapping rule cited in the next section covers bundles of boxes; for banding a single box, check the current UPS guide.
The practical rule is simple: follow the rules of the carrier you ship with. A box banded for USPS should not go to FedEx as it is. If the rate you want lands at FedEx, tape the box to the H pattern and leave the bands off, or keep the box with a carrier whose rules allow the banding.
Can you strap two boxes together as one UPS package?
UPS allows it under limits, and the limits make it less useful than it looks. According to the UPS daily rates guide, only same-sized boxes may be strapped together, with at least four crisscrossed bands (two in each direction), and each box needs its own address label. Each box must be able to hold the weight of the whole bundle. So two 15 lb boxes banded together need boxes rated for 30 lb each. An Additional Handling charge may also apply.
| Example: two same-sized boxes, 25 lb each, banded for UPS | What it means |
|---|---|
| Bundle weight | 50 lb |
| Rating each box needs | Strong enough for 50 lb, the whole bundle |
| Bands | At least 4, crisscrossed, 2 in each direction |
| Labels | An address label on each box |
| Cost risk | An Additional Handling charge may apply |
In that example, each 25 lb box must be rated for twice its own weight. Two separate labels let each box travel on its own rating with no bundle rules, though each box is then billed as its own parcel. The tradeoffs are covered in splitting a heavy shipment into two boxes, and the fee triggers are in UPS Additional Handling and Large Package surcharges. Do not assume other carriers treat a strapped pair the same way. FedEx says packages should not be banded.
What should never go on the outside of a heavy box?
String, rope, twine, outer wraps and hanging tags are each ruled out by at least one carrier. The UPS packaging guidelines say not to use string or paper over-wrap. FedEx says not to use string or rope, and not to wrap the outer box in shrink wrap, stretch wrap or Bubble Wrap. USPS says twine or cord should not be used.
Labels have their own rules. UPS says not to use "flying tags" attached by string or metal, and to tape the label to a flat surface instead. Place the label on a flat panel clear of bands and tape seams, so a strap or strip end does not cross the barcode. Beyond that, label guidance differs by carrier, so follow the label rules of the carrier you ship with.
Where GoatLabels fits
GoatLabels rate-shops USPS, UPS and FedEx on every domestic parcel, and DHL on international lanes, from one account, with one price per rate. That matters here because your packing has to match the carrier you buy: if a box is banded and the rate you like is at FedEx, retape it or choose another rate before you buy. When you split a load instead of bundling it, each box can get its own label carrying the same reference. Free is $0 a month for 50 shipments, and Pro is a flat $40 a month with unlimited shipments; see pricing.
GoatLabels does not inspect how a box is packed, taped or strapped, so meeting each carrier's tape and banding rules is up to you. Carrier adjustments after delivery, such as re-weighs and dimension corrections, post to the same prepaid wallet, so the quote is not always the last charge. GoatLabels books parcel labels only, not LTL or freight.